|
- Now I am going to get ready to sew my curved units together… First, I’m going to clip down to
the edge of where I sewed inside the seam allowance, across both unit A and B… I clip both units, whether or not that’s
the “correct way” I don’t know, its just My Way J
- Ok, here’s where the explaining gets very tricky- Once everything is all clipped, I line the Right
edge of my unit A (face down) along the Right edge of my Unit B (face up) as shown below… I insert a pin, making sure
it hit’s the corners of my paper templates on both pieces. Then pin in place, keeping the pin fairly high up because
I want to have flexibility when pinning the rest of the places.
- Now I’m going to pull the left side of unit A and line it up with the left side of unit B as shown below ( See how
the unit B curves inward, that’s OK its what its supposed to do.. Pin this side in place just as you did the other side…
And once pinned your piece should look like this…
- Now pin the same way, where you marked your center lines…
- and then in-between the center and edge on each side, so your pinned units should look like this:
|
